PAR36 LED Flood Light, Screw Terminal | 2,200 lm Wide Beam | Tractor, Marine & Taxi | 10–30V DC

PAR36 LED Flood Light with Screw Terminals

This is the wide-beam version of our 18-LED PAR36. It's built for lighting up a work area rather than reaching far down a runway: think tractor and combine work lights, a boat's deck or dock light, or the taxi light on an experimental airplane. It drops into a standard 4.5" PAR36 housing and connects to the same two screw terminals as the lamp you're taking out.

• 2,200 lm and 90,000 cd center beam, spread about ±70° side to side
• Draws about 15W, compared with 35–100W for most halogen PAR36 lamps
• Runs on 10–30V DC, so it works on 12V and 24V equipment and 28V aircraft
• Rated for 10,000 hours. No filament to shake loose on rough ground
• Die-cast aluminum, IP67 sealed, good for pressure washing, mud and snow
• EMC tested to CISPR 25 Class 3, so it won't put noise on your radio
• Free U.S. shipping, 2-year warranty

Need a long-range beam instead? The Spot version and the Spot + Flood set are on our PAR36 Landing & Taxi Light page.

Where People Use It

• Farm and heavy equipment: tractors, combines, loaders, forklifts, snowblowers
• Marine: deck, spreader and dock lighting. It is not a navigation light.
• Aviation: taxi light on experimental and amateur-built aircraft only. Not FAA or PMA approved.
• Trucks and off-road: work lights and scene lighting on 12V and 24V vehicles

Will It Fit?

• Your old lamp is a 4.5" PAR36. Ours is 111.6 mm across and 43.4 mm deep.
• It connects with two screw terminals. If yours has bare wire leads, get our PAR36 pigtail version instead.
• Your system runs between 10 and 30V DC.

Common lamp numbers it replaces: 4313, 4505, 4509, 4587, 4591, 4593, 4594, 4595, 4596, 4627, 4631, 4632, 5587. Quartz versions: Q4594, Q4631, Q4632, Q5587, Q5596, 55-2477-1. John Deere numbers: AR48723, AR85263, AR85264, AR93335.

Not sure? Send a photo of your old lamp and its part number through our Contact page and we'll check it for you.

Specifications

Installing It

1. Turn off the master switch or disconnect the battery.
2. Take out the old lamp and undo the two terminal screws.
3. Connect positive (+) and negative (−) as marked on the back of the LED.
4. Set the lamp in the housing with the beam running side to side, then fasten it.
5. Power up and check it.

If it doesn't light, the polarity is reversed. That won't hurt it; just swap the wires.

In the Box

• 1 PAR36 LED flood lamp with screw terminals (no pigtail)
• Installation guide and warranty card

Questions We Get a Lot

Will it work on my John Deere?

If the light takes a 4.5" PAR36 with screw terminals, yes. The John Deere numbers above are the ones we see most often. Send us a photo if you want us to check.

Can I use it on a 24V machine?

Yes. It runs on anything from 10 to 30V DC.

Is it a landing light?

No, this is the wide flood beam. For a landing light you want the Spot on our PAR36 Landing & Taxi Light page.

How long does shipping take?

Shipping is free in the U.S. Orders go out from U.S. stock and usually arrive in 2–5 business days.