April 27, 2019
April 27, 2019
April 27, 2019
Archive
Tags
Recent Posts
April 27, 2019
This LED is built-in driver, so customer do not need extra driver or transformer. You can just connect this PAR36 bulb to DC 12 Volt or DC 24 Volt.
April 27, 2019
Before 2019, the lens is glass. From Jan 1st, 2019, the lens was upgrade to plastic due to the high defect rate during shipping.
April 27, 2019
1.You can cut off the ends of your wires and either splice the wires together of install a two wire weather resistant connector in line so you can disconnect the light or needed. That's what I did and it works great. Trouble free and super bright.
2. I changed all the w...
April 27, 2019
No just hook it up to 12 volt power and ground. Remarks: 12 volt -DC power.
April 27, 2019
It should fit into a standard 4" opening, it has the same flange front and 4" step in the back as a halogen "Capsulelight" It does stick out more in the back than the regular bulb. Dimensions on this bulb is 4.5 in x 2.88 in deep. Hope that helps.
April 27, 2019
This lamp's real dia is 111.6mm, we think it can also replace a GE 4406-1 bulb.
April 27, 2019
The real AMP is 1.0A/14.0V, 0.5A/28.0V. Due to the low AMP, we do think it must connect with fuse. But if you install with fuse, like 5A fuse, that could be more better.
April 27, 2019
It fit my Unity H-1 Spot Light but it was a tight fit. I did a little Dremel grinding in a small area at the bottom near the retaining ring screw but not sure it was really necessary. Not sure, but it is a little bit thicker than std PAR36 bulbs. I used for aviation pu...